Defi Link VSD Concept User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Adhesive tape
Display film
Display film
under 5in
(130mm)
Display unit
D.C.Unit
Defi-Link Control Unit
(or Defi-Link Control Unit)
STEP3 Applying the Display Film
D
ispla
y
must be pro
j
ected on the bottom 5in
(
130mm
)
of the windshield. Consult with customer about the place o
f
displa
y
pro
j
ection. Attach the displa
y
unit in a location which will not hinder drivin
g
. Compl
y
with the law concernin
g
vehicle safet
y
in
y
our district.
The displa
y
is viewable even without the displa
y
film. The transmittance of the displa
y
film is about 45%. We are
not responsible for an
y
dama
g
e or problems arisin
g
from the use of the displa
y
film applied on the windshield.
Please follow the local re
g
ulations as for attachin
g
the displa
y
film
.
W
arnin
g
1:
W
i
p
e off tarnish and stain on the windshield
.
2:Position the display unit and the display film in place. Mark a corner of display film with adhesive tape.
3:Separate the display film from the backing paper using adhesive tape as shown in the following figure.
4:Spray a mixture of water(150ml:5oz) and mild detergent(1 or 2drops) on the windshield and the display film. Attach the
film to the windshield in a longitudinal direction.
Dismount the display unit for a time to protect it from getting wet. Spread a towel on the instrument panel.
5:Gently squeeze out water and air bubbles under the film using a spatula. Wipe extra water with tissue.
When the Defi-Link Display VSD CONCEPT is used WITH a connection to the Defi-Link System
When the Defi-Link Display VSD CONCEPT is used WITHOUT a connection to the Defi-Link System
STEP2 Check Wiring
Do not expose D.C.Unit and Defi-Link Control Unit II(or Defi-Link Control Unit) to direct sunlight.
1:Connect the display wire of Defi-Link Display VSD CONCEPT to DISPLAY UNIT of D.C.Unit.
2:Check that all the wires are properly connected.
3:Turn on the ignition of vehicle and make sure the display is lighted.The display looks inverted on the display unit.
4:If the display is lighted, go to the next step. If not, go back to STEP1(WIRING) and rewire.
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments