Defi Link Meter User Manual download pdf (Page 45)

＊Regarding the oil pressure and fuel pressure gauges, the warning LED

goes on at a lower value than the set value and a buzzer sounds.

＊When the ignition switch is turned on but the engine is not started, the oil

pressure sensor reads 0kPa and a buzzer sounds due to the warning

condition.

＊Setting the warning value for Intake manifold pressure:

The gauge pointer indicates the maximum on the scale to point the initial

warning value. Press the DOWN switch for more than 13 seconds until

the pointer starts to move.

「WARNING SET MODE」

If the Control Unit Ⅱ WARN SET switch is

pressed, WARNING LEDs of all gauges will

blink all at once. This is the warning set

mode. The LED of gauge to be set will flash

quickly.

＊WARNING values of each gauge can be

set by pressing UP/DOWN switches.

＊The pointer will move faster by pressing

the UP/DOWN switches for a long period.

Every time the WARN SET switch is

pressed, the gauge to be set up changes.

If the switch is not pressed for more than 5

seconds after the warning value is set up,

WARNING LED(red) goes off. After the LED

goes off, setup is completed and gauges

return to REAL MODE.

「WARNING SET MODE」

Control Unit Ⅱ

●It is very dangerous to set gauges during driving.

Please set while the vehicle is stopped.

WARNING

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 56 57

No comments

Defi Link Meter User Manual Page 45